8 replies to this topic

[Rootman]

I've been using PE for years, switched from the old Bart PE to Reatogo to Winbuilder with VistaPE. I've muddled around and got it to work just fine till I hit the Dell H700 RAID controller.

It doesn't seem to be supported in the DriverPacks.net drivers. I keep seeing a reference to
"VistaPE Driver Integrator" and can't find it.

Can anyone point me into the right direction on how to integrate the driver for the H700 into VistaPE? BTW: I am using Windows 2008 X86 as a source.

[maanu]

if you have the files in hand , then plz zip them and attach to your next post..

[Rootman]

Wow thanks!

Attached is the Dell H700 SAS PERC drivers for Windows 2008 X86 which is what I suppose VistaPE built against a 2008 X86 source would need.

Attached Files

•  R244730.zip   26.1KB   450 downloads

[maanu]

Wow thanks!

Attached is the Dell H700 SAS PERC drivers for Windows 2008 X86 which is what I suppose VistaPE built against a 2008 X86 source would need.

are you sure that it is NOT only for server 2003 64bit ?

anyways have a look here ,

http://www.boot-land...art=#entry91031

or in the same topic , post by dera

[Rootman]

I choose it off the Dell site for WS08 X86, one of the INFs contain this:

----------- WINDOWS Server 2008/Vista 32BIT INSTALL SECTION ----------------------------------------------------------

[dera]

here is DaveXP's tool, uses peimg
 DaveXP_peimg_driver.7z   249.13KB   418 downloads
and here is the original thread

[Rootman]

Dera, thanks.

AFAIK the current driver pack does not support the H700 RAID card, I'll try the custom folder.

Thanks again!

[Rootman]

Maanu,
Thanks for the link, however I am strictly using Vista / 2008 and don't have DISM.

Thanks for your efforts.

[Rootman]

Dera,
The Dave's PE Image Driver worked by putting the files into a folder and pointing the Custom folder to it.

Thank you sir (or madam as it may be )