General request(s)

Great product so far.

Sooner than later add:

- isosel load on every boot

- boot to local harddrive option in isosel (like on ESXi installer) and the option to make that the default selection

- one time boot of current ISO then automatically delete, blank or rename the iso_filename.txt or default to local harddrive

- update firmware by dropping a file on the flash - instead of the button and updater software

Next generation:

- smaller case

- rear LED indicator

Great product so far.

Thanks

Sooner than later add:

- isosel load on every boot

This is currently in internal beta as seen here, pending this nasty bug fix.

- boot to local harddrive option in isosel (like on ESXi installer) and the option to make that the default selection

- one time boot of current ISO then automatically delete, blank or rename the iso_filename.txt or default to local harddrive

Sounds good, I'll add cards for these on Trello.

- update firmware by dropping a file on the flash - instead of the button and updater software

Not possible with the current hardware, but maybe the next-gen one. The problem here is the bootloader, which cannot be replaced without risk of bricking the device, has very limited functionality.

However, I plan on removing the need to push the button, and roll the update functionality into ISO Manager while keeping it as a portable executable, no installation required. Prettymuch just a way for ISO Manager to tell the isostick to jump into its bootloader to accept an update, but the update would still go out over USB serial. See here.

Next generation:

- smaller case

- rear LED indicator

No problem