My relatives PC failed. The PC had a hard disk with g4d installed to the MBR. Three primary and a few logical partitions. He got a new processor + mobo.
With a Intel G6400 processor and Gigabyte GA H410M H motherboard, I'm not able to boot from the hard disk.
I have a UFD with grub4dos installed to the MBR, and that won't boot too.
In both cases after the PC boots, there is a blank screen.
I have enabled CSM.
I remember the previous mobo BIOS had a option "Boot Mode Selection" which was set to "Legacy only". This option does not exist for the new mobo.
I would like to use g4d, what BIOS settings should I enable ?
See screenshots attached. First one is from the mobo manual.
(Toshiba transmap ... is the UFD, btw)